 |
| The mortise lengths are no longer the same, due to the earlier fitting... |
 |
| So the shoulder is used to place the 45 degree cut in the correct location. |
Next, is a full dry assembly, followed by the fitting of the two non-adjustable shelves.
Tuesday, November 1, 2011
Cutting the Tenons (Part 3)
One last operation to complete on the tenons before I start assembling the shelf. I need to cut a 45 degrees section out, so the tenons will fit together in the corners. Fortunately, this is a quick operation.
Next, is a full dry assembly, followed by the fitting of the two non-adjustable shelves.
Next, is a full dry assembly, followed by the fitting of the two non-adjustable shelves.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment