T-Box Legs: A shelf and some gussets.

This post covers the installation of the bottom shelf, and the upper gussets.

The first part of the process, where the shelf is trimmed to size is not shown. The trimming was done with a router fitted with a spiral cutting bit. The end result looks quite neat.

Bottom shelf, fitted and ready for final installation.

Clamped in place, and drying.

Future gussets.

Used a sled to cut at a 45 degree angle...

...and routed out the corners.

Rounded over the edge as the last fabrication step.

Drying in place, bottom view.

Drying in place, top view.

The T-Box legs are almost complete... just need a few bits here and there to strengthen the table in critical spots, especially around the caster mounting points.